Rosen Entertainment Systems RVR 2000 - Manual (Page 5)

Rosen Entertainment Systems
To Open the DVR Door and Install the DVR:
Slide the DVR latch to the left to release the door. Place the DVR
inside the door slot with the Rosen logo facing downward and the
connection jack pointing upward towards the unit. Slide the DVR
into the door slot, making sure that it is fl ush with the bottom of
the door and centered. Slide the DVR carefully, until it connects
to the jack. Close the DVR door. If seated properly, the door
should have no problem closing fl ush to the underside of
the T10/T12. If the door does not easily close or is not fl ush,
carefully re-seat the DVR and try again.
To Watch a DVR Video:
1. Press SOURCE on the remote control or the control panel
module (CPM) on the T10/T12 until “DVR” is displayed.
2. Use the UP/DOWN/LEFT/RIGHT navigation arrow buttons to
select the “VIDEO” icon and press ENTER.
3. Use the UP/DOWN navigation arrows to select a video fi le for
playback. Press PLAY.
Use the system with the vehicle’s engine running or with the
ignition key switch in the accessory (ACC) position.
Make certain that the remote and the headphones have their
batteries properly installed.
To Lower the Screen and Switch On the System:
GETTING STARTED in the Car
Be sure the ignition key is in the “ON” or “ACC” position.
Press the ENTER button on the front panel or the POWER
button on the remote. The screen will open and the system
will turn on.
7
ACC or engi
ON position
ENTER
DVR Menu Screen:
DO NOT force the DVR door closed! !