Warranty – RIDGID RD8000 User Manual

Page 23

Advertising
background image

23 — English

EVAPORATIVE EMISSION CONTROL WARRANTy
Your new RIDGID brand gasoline-powered product complies with all

applicable U.S. EPA, Environment Canada, and State of California

emissions regulations.
The evaporative emissions portion of this coverage, as described below,

is provided by One World Technologies, Inc. Separate emissions war-

ranty coverage for other emissions-related components is provided

by the engine manufacturer, as stated in a separate “Emission Control

System Warranty” included with this product. Of course, this product

also includes a warranty that is not limited to emissions-related com-

ponents, as described elsewhere in this operator’s manual.
EVAPORATIVE EMISSION CONTROL WARRANTY STATEMENT
CALIFORNIA EVAPORATIVE EMISSION CONTROL WARRANTy

STATEMENT
yOUR WARRANTy RIGHTS AND OBLIGATIONS
The California Air Resources Board and One World Technologies, Inc.,

are pleased to explain the evaporative emission control system’s war-

ranty on your 2009 model year generator. In California, new equipment

that uses small off-engines must be designed, built, and equipped to

meet the State’s stringent anti-smog standards. One World Technolo-

gies, Inc., must warrant the evaporative emission control system on

your generator for the period listed below, provided there has been no

abuse, neglect or improper maintenance of your equipment.
Your evaporative emission control system may include parts such as:

carburetors, fuel tanks, fuel lines, fuel caps, valves, canisters, filters,

vapor hoses, clamps, connectors, and other associated components.

For engines less than or equal to 80 cc, only the fuel tank is subject

to the evaporative emission control warranty requirements of this

section.
MANUFACTURER’S WARRANTy COVERAGE:
This evaporative emission control system is warranted for two years. If

any evaporative emission-related part on your equipment is defective,

the part will be repaired or replaced by One World Technologies, Inc.
OWNER’S WARRANTy RESPONSIBILITIES:

As the generator owner, you are responsible for performance of the

required maintenance listed in your operator’s manual. One World

Technologies, Inc., recommends that you retain all receipts covering

maintenance on your generator, but One World Technologies, Inc.,

cannot deny warranty solely for the lack of receipts.

As the generator owner, you should, however, be aware that One

World Technologies, Inc., may deny you warranty coverage if your

generator or a part has failed due to abuse, neglect, or improper

maintenance or unapproved modifications.

You are responsible for presenting your generator to a One World

Technologies, Inc., distribution center or service center as soon as

the problem exists. The warranty repairs should be completed in a

reasonable amount of time, not to exceed 30 days.

If you have a question regarding your warranty coverage, you should

contact One World Technologies, Inc., at 1-866-539-1710.
DEFECTS WARRANTy REQUIREMENTS:
(a) The warranty period begins on the date the equipment is delivered

to an ultimate purchaser.

(b) General Evaporative Emissions Warranty Coverage. The equipment

must be warranted to the ultimate purchaser and any subsequent

owner that the evaporative emission control system when installed

was:

(1) Designed, built, and equipped so as to conform with all applicable

regulations; and

(2) Free from defects in materials and workmanship that cause the

failure of a warranted part for a period of two years.

(c) The warranty on evaporative emissions-related parts will be inter-

preted as follows:

(1) Any warranted part that is not scheduled for replacement as

required maintenance in the written instructions must be war-

ranted for the warranty period defined in subsection (b)(2). If any

such part fails during the period of warranty coverage, it must be

repaired or replaced by the manufacturer issuing the warranty.

Any such part repaired or replaced under the warranty must

be warranted for a time not less than the remaining warranty

period.

(2) Any warranted part that is scheduled only for regular inspection

in the written instructions must be warranted for the warranty

period defined in subsection (b)(2). A statement in such written

instructions to the effect of “repair or replace as necessary”

will not reduce the period of warranty coverage. Any such part

repaired or replaced under warranty must be warranted for a

time not less than the remaining warranty period.

(3) Any warranted part that is scheduled for replacement as required

maintenance in the written instructions must be warranted for

the period of time prior to the first scheduled replacement point

for that part. If the part fails prior to the first scheduled replace-

ment, the part must be repaired or replaced by the manufacturer

issuing the warranty. Any such part repaired or replaced under

warranty must be warranted for a time not less than the remain-

der of the period prior to the first scheduled replacement point

for the part.

(4) Repair or replacement of any warranted part under the warranty

provisions of this article must be performed at no charge to the

owner at a warranty station.

(5) Notwithstanding the provisions of subsection (4) above, warranty

services or repairs must be provided at distribution centers that

are franchised to service the subject equipment.

(6) The owner must not be charged for diagnostic labor that leads

to the determination that a warranted part is in fact defective,

provided that such diagnostic work is performed at a warranty

station.

(7) Throughout the evaporative emission control system’s warranty

period set out in subsection (b)(2), the manufacturer issuing the

warranty must maintain a supply of warranted parts sufficient

to meet the expected demand for such parts.

(8) Manufacturer approved replacement parts must be used in the

performance of any warranty maintenance or repairs and must

be provided without charge to the owner. Such use will not re-

duce the warranty obligations of the manufacturer issuing the

warranty.

(9) The use of any add-on or modified parts will be grounds for dis-

allowing a warranty claim made in accordance with this article.

The manufacturer issuing the warranty will not be liable under

this Article to warrant failures of warranted parts caused by the

use of an add-on or modified part.

(10) The manufacturer issuing the warranty shall provide any docu-

ments that describe the warranty procedures or policies within

five working days of request by the Air Resources Board.

EMISSION WARRANTy PARTS LIST:
1) Fuel Tank
2) Fuel Cap
3) Fuel Hoses
4) Carbon Canister
5) Vapor Hoses
6) Hose Clamps
7) Hose Connectors
8) Vapor/Fuel Check Valve
Written instructions for the maintenance and use of the evaporative

emissions control system by the owner shall be furnished with each

new generator.

WARRANTy

THE FOLLOWING CALIFORNIA AIR RESOURCES BOARD (CARB) STATEMENT ONLy APPLIES TO MODEL NUMBERS
REQUIRED TO MEET THE CARB REQUIREMENTS.

Advertising
This manual is related to the following products: