RCA MACINTOSH CDS1000 - Manual (Page 42)

References
38
Q: Why does an “ERASE ERROR” message appear on the LCD when erasing
a picture?
A: A power interruption occurred before the erasing of a picture was complete.
Use the ERASE ALL or FORMAT CARD command (under the MENU button in
play mode) and make sure that no power interruption occurs. If the error still
persists, send the camera to an authorized service center.
Q: Why does a “CHARGE ERROR” message appear on the LCD screen?
A: The flash charging unit may be damaged. Send the camera to an authorized
service center for repair.
Q: Why is the image display on the LCD screen so light or so dark?
A: The BRIGHT setting needs to be adjusted. Slowly rotate the BRIGHT dial on
the bottom of the camera clockwise or counterclockwise until a preferred level is
displayed on the LCD.
Q: Why is there no picture on the TV monitor when the camera is connected to
the VIDEO IN jack?
A: The connection between the camera and the TV is loose. Make sure that all
fittings are snug. If this does not work, verify that your TV is set to its video input
“channel.” For more information about finding your TV’s video input line, see
the User’s Manual that came with it.
Q: Why can’t the camera communicate with a computer?
A: There could be a disconnected wire between the camera and the computer.
Make sure that all fittings are snug and correct and that the camera is turned on. If
this does not work, verify that you have installed the software correctly and that
the port used by your serial cable is turned on.
For more information about software installation, see the documentation that
came with the disks.
For more information about turning on your computer’s port, see your computer’s
documentation.