Raypak RFSDV34RFPAU - Manual (Page 12)

glass and causes lint, dust and other air-borne particles to cling. Initial
paint curing may also deposit a slight film on the glass.
Clean the glass two or three times with a non-ammonia based household
cleaner and warm water. (We recommend gas fireplace glass cleaner.)
After the initial cleaning, clean the glass two or three times during each
operating season, depending on the environment.
Log Set and Lava Rock Material Installation
1. Remove window frame assembly. (See window frame removal
assembly section)
2. Remove logs from packaging.
Warning: Plastic bags are not toys and should be kept away
from children and infants.
3. Place rear log (KR10) on rear bracket (ensure log is seated.
properly, levelled and centred to the unit), so it will not move from
side to side and is firmly positioned on the bracket.
4. Slip front ember log (KR7) down behind the front deflector.
5. Place front left log (KR8) on top of burner, left side. Using the
bottom holes in the log, locate it into the left bracket log locator
studs.
6. Place front right log (KR9) on top of burner, right side. Use the log’s
bottoms holes to locate it into the right bracket log locator studs.
7. Place burner lava rock on top of burner between the ember log and
the two front logs.
8. Place top left log (KR11) onto locator notches. Ensure the log is
secure.
9. Place top right log (KR12) onto locator notches. Ensure log is
secure.
Fig. 3 Logs for the RFSDV34 gas log fire
Maintenance
Raypak Australia recommends that this appliance is serviced by qualified and
licensed Service Person at least once a year.
For service repairs and maintenance, Contact Rheem Service on 131 031.
Page 12 of 27