Rhino Mounts RHD88 - Manual (Page 138)

MAINTENANCE
RHD 02/11 Maintenance Section 5-8
© 2011 Alamo Group Inc.
MAINTENANCE
To Disassemble Universal Joint
1. Remove all snap rings.
2. Position joint in loose vice, strike top arm of
unsupported yoke to drive the top cup up.
Repeat on opposite side.
3. If you cannot grip the loosened cap per Step 4,
use a pointed tool to tip a needle them repeat
Step 2.
4. Grip loosened cup in vise, strike yoke arm to
drive yoke off cup. Repeat on opposite cup.
5. Support cross in loose vise and strike yoke arm.
Repeat Step 4 to remove remaining two cups.