Rhino Mounts RHD88 - Manual (Page 90)

ASSEMBLY
RHD 02/11 Assembly Section 3-2
© 2011 Alamo Group Inc.
ASSEMBL
Y
General
The mower comes shipped from the factory completely set up. The only assembly required is to remove the
driveline from its shipping position and attach it to the gearbox.
Driveline Attachment
Before starting assembly, make certain that all
paint, dirt, and grease are removed from gearbox
shaft (1). To ease assembly apply a light coat of
grease to splines and assemble. Do not assemble a
drive line without a shield.
Attach the slip clutch end of the driveline to the
gearbox input shaft securely. Make certain that the
slip clutch is fully onto the input shaft splines.
Tighten the locknuts (2) alternately until they have
reached the proper torque. See Figure ASMP-FL-
0017.
Refer to Torque Chart in the Maintenance Section.