Parameter list, Patch parameters, Patches – Roland JUNO-D User Manual

Page 106

Advertising
background image

106

Parameter list

Patch parameters

Patches

Patch Common parameters (p. 45)

Patch Tone parameters (p. 46)

Patch Effects parameters

* The same parameters are also provided for Rhythm sets.

Parameters

Value

Name

Patch Name

space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ ¥ ] ^ _
` { | }

Category

* Refer to

“Selecting a patch by category”

(p. 20).

Key Mode

SINGLE, SPLIT, DUAL

Patch Level

0–127

Tone Balance

-64 (LOWER) – +63 (UPPER)

Split Point

A0–C8

Split Arp

Split Arpeggio

UPPER, LOWER, BOTH

Solo Switch

OFF, ON, UPPER, LOWER

ModulationDst

Modulation Destination

UPPER, LOWER, BOTH

PitchBend Dst

Pitch Bend Destination

UPPER, LOWER, BOTH

Modify Dest

Modify Destination

UPPER, LOWER, BOTH
* This is linked with the panel’s [DESTINATION TONE] setting.

ExpressionDst

Expression Destination

UPPER, LOWER, BOTH

Active Exp Sw

Active Expression Switch

OFF, ON

Parameters

Value

No.

Original Tone Number

0001–0640

Tone Pan

L64–63R

MFX Switch

Multi-Effects Switch

BYPASS, ON

Chorus Send Lvl

Chorus Send Level

0–127

Reverb Send Lvl

Reverb Send Level

0–127

Coarse Tune

-48– +48

Fine Tune

-50– +50

Portamento Sw

Portamento Switch

OFF, ON

Portamento Time

0–127

Velo Sens Depth

Velocity Sensitivity Depth

-64– +63

Velo Sens Ofs

Velocity Sensitivity Offset

-64– +63

Pitch Bend Range

0–24

Filter LFO

Filter LFO Switch

OFF(PCH), ON(FLT)

LFO Rate

-64– +63

LFO Depth

-64– +63

LFO Delay

-64– +63

Cutoff Freq

Cutoff Frequency

-64– +63

Resonance

-64– +63

Attack Time

-64– +63

Decay Time

-64– +63

Release Time

-64– +63

Parameters

Value

Multi-effects group

Type

Multi-effects Type

00 THROUGH–47 FBK RIPPER

---

Multi-effects Parameters

The number of parameters varies depending on the Multi-effects
Type. Refer to

“Setting multi-effects parameters”

(p. 68).

Send Lvl to Cho

Multi-effect send level to chorus

0–127

Send Lvl to Rev

Multi-effect send level to reverb

0–127

Ctrl 1

Multi-effects Control 1

Refer to

“Setting multi-effects parameters”

(p. 68).

Ctrl 2

Multi-effects Control 2

Refer to

“Setting multi-effects parameters”

(p. 68).

Chorus effects group

Type

Chorus type

CHORUS1, CHORUS2, CHORUS3, CHORUS4, FEEDBACK
CHORUS, FLANGER, SHORT DELAY, SHORT DELAY(FB)

Pre-LPF

Chorus pre-low pass filter

0–7

Level

Chorus Level

0–127

JUNO-D_e.book 106 ページ 2004年6月11日 金曜日 午後1時21分

Advertising