Restoring the factory settings (factory reset), Transmitting the settings of a user performance, Transmitting all data stored in the user area – Roland JUNO-D User Manual
Page 61
61
Playing more than one sound simultaneously (Performance mode)
Performance Mode
Transmitting performance settings
from the MIDI OUT connector (XFER
to MIDI)
You can transmit the settings of the current performance or user
performance from the MIDI OUT connector. This function lets you
save performance settings on an external sequencer. If you select
“DUMP ALL” for the menu, you can transmit all data stored in the
user area to an external sequencer.all data stored in the user area
1.
Press [PERFORM] so it is lit and you are in Performance
mode.
Select the performance you want to output.
2.
Press [UTILITY].
3.
Use PAGE/CURSOR [
]/[
] to select “3:XFER to MIDI.”
4.
Press [ENTER].
Transmitting the settings of currently
selected performance
This operation lets you transmit the settings of the current (edited
and unsaved) performance.
5.
Use VALUE [-]/[+] to select “CUR PERFORM.”
fig.r06-76_40
6.
Press [ENTER].
The currently selected performance settings will be transmitted
from the MIDI OUT connector.
When the display indicates “COMPLETED,” the transmission has
been completed.
Transmitting the settings of a user
performance
5.
Use VALUE [-]/[+] to select “USER PERFORM.”
fig.r06-77_40
6.
Press PAGE/CURSOR [
].
Specify the range of performances whose settings you want to
transmit.
Use VALUE [-]/[+] to specify the first performance of the range
of performances you want to transmit.
fig.r06-78_40
7.
Press PAGE/CURSOR [
].
Use VALUE [-]/[+] to specify the last performance of the range
of performances you want to transmit.
fig.r06-79_40
8.
Press [ENTER].
The performance settings of the specified range will be
transmitted from the MIDI OUT connector.
When the display indicates “COMPLETED,” the transmission
operation has been completed.
Transmitting all data stored in the user
area
5.
Use VALUE [-]/[+] to select “DUMP ALL.”
fig.r06-77_40
6.
Press [ENTER].
All data stored in the user area will be transmitted from the
MIDI OUT connector.
When the display indicates “COMPLETED,” the transmission
operation has been completed.
If you want to restore the stored data into the JUNO-D once
again, send the data to the JUNO-D’s MIDI IN. Do not operate
the JUNO-D while this data is being received.
Restoring the factory settings
(FACTORY RESET)
You can also perform the FACTORY RESET operation from
Performance Utility.
For more about FACTORY RESET, refer to
factory settings (Factory Reset)”
JUNO-D_e.book 61 ページ ２００４年６月１１日 金曜日 午後１時２１分