Roberts Radio 63I User Manual

Page 104

Advertising
background image

103

Brightness control

The brightness of the display can be adjusted for when the radio is in Standby
and for when it is in use. If you use the unit in the bedroom, you may prefer
a lower standby brightness level than the standard setting. There are three
brightness levels and an almost off 'night-time' setting.

1. Press the On/Standby button to switch on your radio. Access the menu

for the current mode by pressing and holding the Menu button.

2. Press the Menu Up or Down buttons until 'System settings' is highlighted on

the display. Press the Select button to enter the system settings menu.

Press

the

Menu Up or Down buttons until 'Brightness' is highlighted on

the display. Press the Select button.

3. To adjust the display brightness when the radio is switched on press the

Menu Up or Down buttons until 'Normal' is highlighted on the display.

To adjust the display brightness when the radio is in standby press the
Menu Up or Down buttons until 'Standby' is highlighted.

Press

the

Select button to enter the selected brightness adjustment

mode.

4. To adjust the brightness level press the Menu Up button on the radio to

increase the brightness level and the Menu Down button to decrease it.

The backlight level will change so that you can see the effect of each
setting. Note that the backlight is almost completely off at the zero setting.
Press the Select button to set the level.

Press and hold the Menu button to exit.

When the radio is in Standby mode, pressing a button will cause the radio to
switch to the Normal brightness level for a few seconds. This is so that even
if the Standby brightness level is set to zero (almost off), it is still possible to
see the time by quickly pressing a button.

2-4

2-4

2-4

1

Advertising