Rimage 360i - Manual (Page 20)

Rimage 360i
14 110808_C
Centering the image on the disc
The Rimage 360i provides two ways to center the image on the disc. You can use the Auto
Centering method or the Manual Centering method. The Auto Centering method is accurate to
within +/- 0.5 mm. You can improve the centering position accuracy with the manual centering
adjustment to better than +/- 0.2 mm. For optimal print quality, use this procedure to center the
image on the disc.
#
Tip: Use the Center Image
functionality only if the
printed image is not
centered on the disc. Image
centering is set at the time
of manufacture and usually
does not need to be
recalibrated in the field.
1. Navigate to Printing Preferences (refer to page 9).
2. At the Rimage 360i, open the front cover.
3. To open the printer tray, press the green (middle) button inside the
front cover of the Rimage 360i. The printer tray opens.
4. On the Service tab, select the Service ToolBox button.
5. Select the Center Image button. The Centering Margins for Disc
Color 360i dialog box displays.
6. Follow the directions in the dialog box to:
Auto center the image
Or
Manually center the image
7. When the image is centered, select OK to close the Centering
Margins for Disc Color Printer 360i dialog box.
8. To close the Rimage Service ToolBox window, select OK.
9. To close the Disc Color 360i Properties window, select OK.
10. To close the printer tray, press the green (middle) button. The printer
tray closes.
11. Close the front cover.
#
Tip: If you remove the ink
cartridges and reinsert
them, the system resets to
show that the cartridges are
full, regardless of the actual
fill status.
Checking the ink levels
This functionality allows you to check the level of ink in the cartridges.
1. Navigate to Printing Preferences (refer to page 9).
2. On the Service tab, select the Service ToolBox button.
3. Select the Get Ink Level button. Ink level information displays in the
Printer Status field.
4. To close the Rimage Service ToolBox window, select OK.
5. To close the Disc Color 360i Properties window, select OK.