Rimage 360i - Manual (Page 21)

Maintain the Rimage 360i
Maintain the Rimage 360i
The procedures in this section will help keep your Rimage 360i in optimum operating condition.
General Cleaning
#
Tip: To keep your Rimage 360i
clean, keep it in a dust free
environment.
Cleaning the exterior
If your Rimage 360i becomes dusty:
1. Power off the Rimage 360i.
2. Wipe the exterior with a damp, lint-free cloth.
#
Tip: Use only Rimage inkjet print
cartridges and, for best results,
follow the guidelines below:
• Keep print cartridges sealed in
the original package until they
are needed.
• Store print cartridges at room
temperature (60 - 78 degrees
F or 15.6 to 26.6 degrees C)
• Store print cartridges in an
upright position - not on their
sides or upside down.
• Do not remove the protective
tape from a new print cartridge
until just before you install it.
Once you remove the tape, do
not reapply it.
• After you have removed the
protective tape, avoid touching
the contacts and nozzles.
• Print at least once a month to
keep the print cartridges in
good working order.
Cleaning the ink cartridge nozzles
This functionality allows you to clean or open the ink cartridge
nozzles. The nozzles may become clogged from dried ink
causing poor print because one or more nozzles are not
delivering the appropriate quantity of ink.
1. Navigate to Printing Preferences (refer to page 9).
2. On the Service tab, select the Service ToolBox button.
3. Select the Clean Cartridges button. The Cleaning
Cartridges window opens.
4. To clean the ink cartridge nozzles using the least amount
of ink, select Light. The status field at the bottom of the
Cleaning Cartridges window displays a message when the
cleaning is complete.

Note: Print a test disc after cleaning the ink cartridge
nozzles. If the print quality is poor, repeat this process
and, in step 4, select Medium or Heavy to clean the ink
cartridge nozzles.
5. To close the Cleaning Cartridges window, select OK.
6. To close the Rimage Service ToolBox window, select OK.
7. To close the Disc Color 360i Properties window, select
OK.
110808_C 15