Roland BOSS DIGITAL RECORDER MICRO BR - Manual (Page 24)

24
Getting ready to use the MICRO BR
921
941
942
1. Check the following points before you
turn the power on.
• Is the MICRO BR correctly connected to your
external equipment?
• Are the volume controls of the MICRO BR and
your connected equipment set to the minimum
position?
• Is a memory card inserted?
2. Lower the MICRO BR’s VOLUME.
3. Switch on power to the device that’s
connected to the input jack (GUITAR IN,
LINE IN/MIC).
4. Press the [POWER] button on the top
panel to turn it on.
5. Switch on power to the device that’s
connected to the output jack (PHONES/
LINE OUT).
1. If the MICRO BR is communicating with
your computer via USB, break the
connection as described in “Breaking the
connection with your computer” (p. 104).
2. Make sure that song playback is stopped.
3. Make sure that the display does not
indicate “Keep power on!”
4. Power off each device in the opposite
order from which you turned them on.
5. Press and hold down [POWER] until the
display indicates “Shutting down...”
Turning the power on
• To prevent malfunction and/or damage to
speakers or other devices, always turn down
the volume, and turn off the power on all
devices before making any connections.
• Once the connections have been completed
(p. 22), turn on power to your various
devices in the order specified. By turning on
devices in the wrong order, you risk causing
malfunction and/or damage to speakers and
other devices.
• This unit is equipped with a protection
circuit. A brief interval (a few seconds) after
power up is required before the unit will
operate normally.
Turning the power off
• If you’re using an AC adaptor, ensure that
the AC adaptor does not become unplugged
during use. Data may be lost if the AC
adaptor is unplugged during use.
• Turn down the volume before you turn the
power on. When you turn the power on, you
may hear some noise even when the volume
is turned down, but this does not indicate a
malfunction.
MICRO-BR_e1.book 24 ページ ２００６年８月１日 火曜日 午後１２時６分