Russound UNO-TS2 - Manual (Page 20)

20
102.5
INSTALLER GUIDE
UNO-TS2 Touchscreen Controller Connections
For One UNO-TS2 per Controller
An RNET controller (CAV6.6, CAM6.6) supports
one UNO-TS2 and up to five UNO keypads per
controller, connected to the UNO System
Keypad Ports located on the rear panel. Caution: 12V Zone triggers on the
RNET controller cannot be used with
this keypad configuration due to 12V
power supply capacity. Use an SA-ZX3
and power supply if triggers are used.
For 2 to 6 UNO-TS2s per Controller
(One UNO-TS2 per Zone)
Each UNO-TS2 must be connected to an SA-ZX3
Keypad Splitter. The SA-ZX3 is powered by a
1201A 1A power supply and uses an RJ-45
CAT-5 patch cable to connect to the controller’s
UNO Keypad Port. The UNO-TS2 connects to the SA-ZX3 with a
CAT-5 110 punchdown on the touchscreen end
and an RJ-45 connection on the SA-ZX3 end.
UNO-S1/S2 keypads can share the SA-ZX3 with
an UNO-TS2, but they must be configured for the
same zone.
102.5
12V Zone trig-
gers cannot be
used with this
keypad
configuration