Russound UNO-TS2 - Manual (Page 23)

23
INSTALLER GUIDE
Other Installer Setup Functions
Firmware Version: X.XX
Screens Version: X.XX.XX
About this keypad
6
1
This screen is shown when “Zone and
Controller ID” is selected This screen is shown when “About”
is selected
Factory Init - This screen allows a factory initialization to be performed on the touchscreen.
This sets the unit back to its factory settings.
This screen is shown when “Factory
Init” is selected This screen is shown when the
Factory Initialization is complete
Several installer-level functions are accessible
from the Installers Setup screen.
About - This screen shows the current firmware
and screen versions on this touchscreen.
Zone and Controller ID - On this screen, enter
the touchscreen’s zone number the UNO-TS2 is
controlling and the ID number of the controller to
which it is connected.
Note: The controller must be power cycled after
the Zone Number and/or Controller ID is
changed on the UNO-TS2
Zone and Controller IDs
Factory Init Factory Init
This will Factory Init the touch-screen only
Are you sure? Factory Init complete