Ricoh G700SE - Manual (Page 37)


4.
Press MENU/OK to accept the new
memo.
The new memo will be recorded with the
next photograph taken.
To delete barcodes read with [Mode3]
selected for [Barcode Mode], highlight the
first item in the camera memo dialog and
press $ to display the description list. Press
! or " to highlight [No Setting] and press
MENU/OK.
Playback Mode
1.
Display a photograph.
Display a photograph to which you wish to
add barcode data.
2.
Press the ADJ./MEMO button.
The [Camera Memo] screen appears.
3.
Press the # button.
You can now read barcode data.
4.
Point the camera toward the
barcode you want to read and press
the # button.
The camera switches to macro mode and
reads the barcode data. When the camera
finishes reading the barcode, the data are
stored as a temporary description for the
first item in the memo.
1234567890
Foundation work
Exterior
Beverly Beech
Gamma Company
Barcode
Const.type
Location
Supervisor
Affiliates
FileName/SAMPLE
Camera Memo 1/45
Ok
If the camera is unable to read the barcode
or if you wish to exit without reading the
barcode, press $ or DISP. to return to the
camera memo dialog. Press # to read the
barcode again.
Non-ASCII characters in the barcode data
will be replaced by asterisks (“*”).
5.
When [Barcode Mode] is set to
[Mode], you can repeat Step 4 and
read additional barcodes.
6.
Press the MENU/OK button to
confirm the camera memo.
7.
Press the MENU/OK button.
The memo will be added to the
photograph.
• You cannot read the same barcode more than
once.
• If, after reading the barcode, you shoot a
picture or change modes and then read
another barcode, the previously registered
barcode data is overwritten.
• If you edited the camera memo before reading
a barcode, the changes to the camera memo
are not retained if the camera is unable to
read the barcode. However, voice memos are
retained.
• You can edit the barcode data registered as a
temporary memo. (GP.31)
• The time available to read barcodes can be
selected using the [Scan Time] option in the
camera memo menu.