Radio Shack Wireless Remote Control System User Manual
Page 12
12
5. Press
ON/OFF
on the receiver to make sure the light
or appliance turns on and off.
6. If
1–8/9–16
on the remote control is set to
9–16
,
press the button under
ON
or
OFF
next to
1
and
9
(labeled on your remote) to turn the light or appliance
on or off.
7. Use your fingernail or another object to remove the
clear cover over the label on the remote, and write
down the location of each Plug ’N Power module you
are using with the system on the label. Then press
the clear cover back onto the remote.
8. Press the button under
ON
next to
1
and
9
on the
remote control to turn on the light or appliance
plugged into the control center module. Or, press the
button under
OFF
next to
1
and
9
on the remote con-
trol to turn off the light or appliance.
So far, we have described how to control just one light or
appliance that is plugged into the Wireless Remote Con-
trol Center. However, you can control up to 16 lights and
appliances by using additional lamp modules, appliance
modules, and wall switch modules.
61-2576.fm Page 12 Wednesday, September 8, 1999 1:50 PM