Radio Shack Wireless Remote Control System - Manual (Page 20)

20
DIMMING OR BRIGHTENING LIGHTS
CONNECTED TO MODULES
Turn on the module by pressing the button on the remote
control that corresponds to the module's unit code. Then
press
or on the remote control to dim or bright-
en the light. Hold the button down until you see the de-
sired brightness level.
Note: Because the control center only turns a lamp/appli-
ance on or off, you cannot use the control center receiver
to dim/brighten a lamp/appliance connected to it.
LOCAL CONTROL OF MODULES
Even through your lights and appliances are connected
to Plug ’N Power modules, you can still turn most of them
on locally using their power switches.
• For most products, simply turn the power switch off
and back on again.
• For three-way lamps, you might have to turn the
lamp's switch several times before the light turns on.
• You cannot manually turn on instant-on TVs or
remote controlled TVs that are connected to Plug ’N
Power modules.
61-2576.fm Page 20 Wednesday, September 8, 1999 1:50 PM