Radio Shack Kameleon 4-in-One - Manual (Page 10)

4- IN -O NE R EMOTE P OWERED B Y K AMELEON
10 Changing Volume Lock
6. To check for codes of other devices,
repeat steps 1 to 5, but substitute the
appropriate device key for each device
you are checking. Write down the
device’s code digits in the appropriate
code boxes on page 8.
CHANGING VOLUME LOCK
The RadioShack 4-in-One Remote is set at the
factory for independent volume control of
each selected device.
However, you may change the Volume Lock
setting to Global Volume Lock so that a
device’s volume will be locked to one mode
(e.g., to control TV volume in all other
modes). After that, if desired, you can
perform Individual Volume Unlock on a
selected device to set its volume control for
independent operation.
L OCKING V OLUME C ONTROL TO O NE M ODE
(G LOBAL V OLUME L OCK )
1. Press and hold P until the IR segment
flashes twice.
2. Enter 9 9 3 and then press the mode key
for the device you want to control
volume (for example, TV). The IR
segment blinks twice.
Now, when you press VOL-, VOL+, or MUTE,
the selected device’s volume will be
controlled, regardless of the mode selected.
U
NLOCKING
V
OLUME
C
ONTROL
F
OR
A
S INGLE D EVICE (I NDIVIDUAL V OLUME
U NLOCK )
1. Press a device key (i.e., VCR, TV, CBL/SAT,
or DVD) where you want the volume
controls unlocked.
2. Press and hold P until the IR segment
flashes twice.
3. Enter 9 9 3 then press VOL-. The IR
segment blinks four times.
4. Repeat steps 1 to 3 for any other device
that you want to have independent
volume control.
Now, after you select a device that has volume
unlocked, pressing VOL-, VOL+, or MUTE will
control the device’s volume only in its own
mode.
U NLOCKING A LL V OLUME C ONTROL
( R ESTORING D EFAULT S ETTING )
1. Press and hold P until the red LED
blinks twice, then release.
2. Enter 9 9 3 and then press VOL+. The IR
Segment blinks four times. Volume is
independently controlled for all
programmed devices.
Volume will again be independently
controlled according to its default states for
all programmed devices.
PROGRAMMING FAVORITE
CHANNEL SCAN
In all modes, the RadioShack 4-in-One
Remote can store a list of up to 10 favorite
channels, in any order, that will be
immediately scanned when FAV SCAN is
pressed (see “Using Channel Scan” on
page 11).
NOTE: Favorite channels can only be
programmed for one mode. After
programming, if FAV SCAN is pressed while in
another mode, the remote control will start a
normal channel scan instead (if applicable to
the selected device).
1. Select a Favorite Channel Mode by
pressing VCR, DVD, CBL/SAT, or TV. The
IR segment flashes once as the selected
device key animates.
RS 4in1 Kam User Manual.fm Page 10 Friday, March 4, 2005 9:09 AM