Radio Shack Kameleon 4-in-One - Manual (Page 11)

O WNER ’ S M ANUAL
Using Channel Scan 11
2. Press and hold P until the IR segment
flashes twice.
3. Using the number keys, enter 9 9 6. The
IR segment will flash twice.
NOTE: If the IR segment displays one
long flash, an error has occurred. Try
repeating this step.
4. Using the number keys, enter a favorite
channel number (e.g., 0 1 2). Then press
P. The IR segment will flash three times
confirming your entry.
NOTE: If the original remote control
required pressing an ENTER key to change
the channel, also press the ENTER key
after the channel number (e.g., 0 1 2
ENTER).
NOTE: If you try entering more than 10
channels, or if more than 10 seconds
elapse between key presses, the remote
automatically exits programming.
5. If desired, repeat step 4 for each channel
to be stored, up to a total of 10 channels.
NOTE: After storing 10 channels, the
remote control will exit Favorite Channel
programming.
6. To exit programming with less than 10
favorite channels stored, press and hold
P until the IR segment flashes twice.
NOTE: If you have entered less than 10
favorite channels and wish to add more,
you will need to re-enter all of the
channels.
NOTE: If you have programmed 10
favorite channels, you will need to reset
the remote to program new channels. See
“Troubleshooting” on page 14.
USING CHANNEL SCAN
In all modes, press the SCAN key to start a 3-
second scan of all channels. If programmed,
press the FAV SCAN key to scan only your
favorite channels to view a desired channel
(see “Programming Favorite Channel Scan”
on page 10).
1. Press VCR, DVD, CBL/SAT, or TV. The IR
segment flashes once as the selected
device key animates.
2. Press FAV SCAN. The IR segments will
display outgoing animation as each
channel is changed.
• If Favorite Channel Scan has been
set up, scanning of favorite
channels will start and cycle
through stored channels for
3minutes or until stopped by
pressing any key.
• If Favorite Channel Scan has not
been set up, scanning will start
with the current channel, then
proceed to the next channel up and
cycle through all channels for 3
minutes or until stopped by
pressing any key.
3. To stop scanning channels at any time,
press any key.
REASSIGNING DEVICE KEYS
The RadioShack 4-in-One Remote can be set
to control a second device. For example, to
control a TV, a cable box, and two DVD
players, you can reassign an unused VCR key
to operate the second DVD player as follows:
1. Press and hold P until the IR segment
flashes twice.
2. Using the number keys, press 9 9 2. The
IR segment flashes twice.
RS 4in1 Kam User Manual.fm Page 11 Friday, March 4, 2005 9:09 AM