Radio Shack Kameleon 4-in-One - Manual (Page 13)

O WNER ’ S M ANUAL
Setting the Sleep Timer 13
C LEARING A M ACRO
1. Press and hold P until the IR segment
flashes twice.
2. Using the number keys, press 9 9 5.
3. Press the key you set up to activate the
macro.
4. Press and hold P until the IR segment
flashes twice.
SETTING THE SLEEP TIMER
The RadioShack 4-in-One Remote includes a
sleep timer that lets you set your devices up to
be turned off after a specified time, even if the
device does not have a sleep function.
E NABLING THE S LEEP T IMER
If the Sleep key does not operate your device’s
built-in sleep timer or activate on the remote,
you must enable the sleep timer for that
mode:
1. Press a mode key (i.e., TV, VCR, CBL/SAT,
DVD).
2. Using the number keys, press 9 7 0. The
top IR segment will blink two times to
show that the sleep timer is available.
The sleep timer is now enabled for that
device. Repeat these steps for each device
where you want to use the sleep timer.
D ISABLING THE S LEEP T IMER
If you prefer to use the device’s sleep timer,
rather than the RadioShack 4-in-One
Remote’s, you may disable the sleep timer for
that mode:
1. Press a mode button (i.e., TV, VCR, CBL/
SAT, DVD).
2. Using the number keys, press 9 7 0. The
top IR segment will blink four times to
show that the sleep timer is no longer
available.
The sleep timer is now disabled for that
device. Repeat these steps for each device
where you want to prevent the use of the sleep
timer.
S ETTING THE S LEEP T IMER
If you want to set any device to turn off after a
specified time:
1. Press a mode key (TV, VCR, DVD, CBL/
SAT).
2. Press the Sleep key until the desired
time is set. The timer increases by 15
minutes each time you press the key, up
to 60 minutes.
When the timer counts down to 0, the remote
sends a “power off ” signal to the selected
device.
The sleep timer will work even if you have
reassigned the mode key to a different mode
(see “Reassigning Device Keys” on page 11).
If you turn off the device yourself, the sleep
timer turns off as well.
CLEARING ALL CUSTOM
PROGRAMMING
The RadioShack 4-in-One Remote contains a
Custom Programming Reset program. You can
use it to remove all custom programming,
except your setup codes and reassigned
device keys.
IMPORTANT: Executing this program will
erase all custom settings for Volume Lock
and Favorite Channels. However, your
device programming remains.
1. Press and hold P until the IR segment
flashes twice.
RS 4in1 Kam User Manual.fm Page 13 Friday, March 4, 2005 9:09 AM