ROTEL RHB-200 - Manual (Page 15)

15
4. Within 30 seconds, press the keypad command
button that you wish to learn (in this example,
the button). The backlighting on the
button turns on and the keypad is ready
to receive the IR code. It will flash six times if
an improper button is pressed (for example,
a device button that cannot be learned).
5. Aim the handheld remote at the oval sensor on
the front of the keypad from a distance of approxi-
mately 1 inch (25 mm). Press and hold the button
on the handheld remote with the command to be
learned (the PAUSE button, in this example).
6. If the command is successfully learned, the
button will flash twice. Six flashes indicate that
the learning failed. If the learning failed, repeat
from Step 4.
7. To learn additional commands, repeat from
Step 4, pressing the next keypad button to be
learned.
8. Exit Learning mode by setting SW7 to the OFF
position. Then, exit invisible layer mode by re-
turning SW1 – SW4 to the off positions.
Programming a SMART Sequence
The four standard device buttons ( , , , )
and the two optional device buttons ( and/or
) can store a sequence of commands to be
sent when the device button is pressed. For ex-
ample, the device button is programmed to
switch the Rotel receiver to the CD input and be-
gin disc play.
You can store a new SMART sequence for any
device button using the following procedure. In
this example, we will program the device but-
ton to select the DVD input, pause for 2 seconds,
and begin disc play.
1. The button lighting flashes to confirm suc-
cessful SMART programming. The backlighting
feature must be active before starting (SW10
in the ON position).
2. Put the keypad into SMART programming mode
by moving SW8 to the ON position. Make sure
that SW7 is OFF.
3. Within 30 seconds, press the keypad device
button where you wish to store the SMART
sequence (in this example, the button).
The backlighting on the button flashes
twice.
4. Press the first step of the SMART sequence. In
this example, press the button, since the first
step is to select the DVD input.
5. Press the next step in the SMART sequence. In
this case, add a two second delay by press-
ing the button twice. This is a special com-
mand; each press adds a one second delay.
6. Press the next command in the sequence. In
this case, the button, since the final step in
the sequence is to start DVD disc playback. Up
to 20 steps can be saved in a sequence. Each
one second delay counts as one step.
7. Exit SMART mode by setting SW8 to the OFF
position: