Roland MC-09 - Manual (Page 55)

55
Changing the way in which a loop plays (Loop Control)
9
Press the [EXIT] button.
You will exit preparatory settings for loop control.
10
Press a step [1]–[16] button to specify the step for which you
will input a value.
If you want to input the same value for more than one step, hold down the
button for one step and press the button(s) for the other step(s).
* It is not possible to input more than one value at each step. If you select a step for which
a value has already been input, the existing data will be replaced by the new data.
11
Turn the C3 knob to input the desired value.
12
Repeat steps 10 and 11 to make loop control settings.
13
When you are finished making loop control settings, press the
[EXIT] or [
] button.
* The settings you make are temporary. If you want to keep your new settings, you
must save them (p. 56).
Type Value Explanation
Pitch -12–12,
(TIE),
(REST)
Raise or lower the pitch by up to 1 octave in semi-
tone steps relative to the original pitch of the loop.
A setting of “1” raises the pitch by a semitone, and
“-1” lowers the pitch by a semitone.
Trigger 1–4,
— (don’t play), Specify the part that will be played.
To stop playback mid-way through, use .
Divide
times 16 1–16 (12),
(REST)
Specify which of the 16 or 12 sections will be
played.
The number of divisions is specified in step 7.
If the loop control length is
set to 2 measures, you can
change the measure
location by holding down
the [SCALE] button to get
the display to show the
measure number, and
pressing the [INC] or
[DEC] button. To check the
current measure location,
press and hold the [SCALE]
button. The previous
display will reappear when
you release the button.