Raritan Computer MCIP18 - Manual (Page 21)

C HAPTER 4: R EMOTE M ANAGEMENT AND O PERATION 13
Chapter 4: Remote Management and Operation
Initial Configuration
MCIP comes pre-configured with the values shown below, and its communication interfaces are
based on TCP/IP. You must perform an initial IP configuration to access MCIP for the first time.
PARAMETER VALUE
IP auto configuration DHCP
IP address 192.168.1.22
Netmask 255.255.255.0
Gateway None
IP access Disabled
LAN interface speed Auto
LAN interface duplex mode Auto
Initial Configuration via DHCP Server
By default, MCIP will try to contact a DHCP server in the subnet to which it is physically
connected. If a DHCP server is found, it may provide a valid IP address, gateway address, and net
mask.
Before you connect the MCIP unit to your local subnet, complete the corresponding configuration
of your DHCP server. Raritan recommends that you configure a fixed IP assignment to the MAC
address of MCIP. The MAC address is located on the outside of the shipping box and on the
bottom of the MCIP unit. If the DHCP connection fails on boot up, MCIP will not have an IPv4
address.
Initial Configuration via Serial Interface
MCIP has a serial line interface on its front panel. The connector is compliant to RS 232 serial
line standard. The serial interface must be configured with the parameters listed below.
PARAMETER VALUE
Bits/second 115200
Data bits 8
Parity No
Stop bits 1
Flow Control None
To configure MCIP via the serial interface:
1. Power OFF the MCIP unit, then power ON again to reset.
2. Press the ESC key on your keyboard. Device information and a prompt appear.
3. Type config and press the Enter key. After a few seconds, lines appear.
4. Type the answers as the questions appear, or press Enter to use the default value (shown here
in brackets).
IP auto configuration (none/dhcp/bootp) [dhcp]: