7 turning on the power, 8 primary lens adjustments, Focus and zoom – Runco QUANTUM COLOR Q-750I User Manual
Page 50: Lens shift, Vertical lens shift, Horizontal lens shift, Turning on the power, Primary lens adjustments, Pre l iminar y
34
Q-750i Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.7
Turning on the Power
1.
Turn on your source components.
2.
If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see above).
3.
Press the ON button on the remote control to turn on the Q-750i. The LED flashes
green to indicate that it is warming up.
4.
When the projector is ready for use, the LED turns off.
3.8
Primary Lens
Adjustments
The Q-750i gives you a great deal of control over the picture size, position and focus.
Focus and Zoom
To focus the projected image, grasp the lens by
the outer ring and rotate it.
To make the picture smaller (zoom out) or larger
(zoom in), move the zoom tab in the appropriate
direction.
Lens Shift
To access the lens shift controls, loosen the Phillips screw at the bottom of the decorative
bezel on the front of the projector (see Figure 2-1). Then, remove the bezel.
Vertical Lens Shift: To shift the
projected image vertically, insert
the provided hex wrench into the
vertical lens shift adjuster at the top
of the projector (directly above the
lens). Then, turn the wrench as
shown to shift the lens in the
desired direction.
Horizontal Lens Shift: To shift the
projected image horizontally, insert
the provided hex wrench into the
horizontal lens shift adjuster at the
top of the projector. Then, turn the
wrench as shown to shift the lens in
the desired direction.
When you have finished adjusting the lens position, re-install the jewelry.
➤
Zoom
in
Focus
Zoom
out
➤
Vertical
Lens Shift
Lens
Horizontal
Lens Shift