Rockford Fosgate 500.2 - Manual (Page 13)

U
SING
P
ASSIVE
C
ROSSOVERS
A passive crossover is a circuit that uses capacitors and/or coils and is placed on speaker leads between the amplifier and
speaker. The crossover delegates a specific range of frequencies to the speaker for optimum driver performance. A crossover
network can perform one of three functions: High-Pass (capacitors), Low-Pass (inductors or coils) and Bandpass
(combination of capacitor and coil).
The most commonly used passive crossover networks are 6dB/octave systems. These are easy to construct and require one
component per filter. Placing this filter in series with the circuit will reduce power to the speaker by 6dB/octave above or
below the crossover point depending on whether it is a high-pass or low-pass filter. More complex systems such as 12dB/
octave or 18dB/octave can cause impedance problems if not professionally designed.
Passive crossovers are directly dependent upon the speaker's impedance and component value for accuracy. When passive
crossover components are used in multiple speaker systems, the crossover's effect on the overall impedance should be taken
into consideration along with the speaker's impedance when determining amplifier loads.
a
d
v
a
n
c
e
d O
p
e
r
a
t
i
o
n
11. After the final inspection is complete, install the power fuse and enjoy listening. During the initial listening period, you
may need to “fine tune” any phasing and level settings within your particular vehicle. To aid in this procedure, play a
track with high musical content and cruise around your neighborhood. After fully evaluating the transient response of
your system and making any final adjustments, all your neighbors within a 1 mile radius will assume that you have
just successfully completed another upgrade to your audio system for which they will probably spill thumbtacks on your
driveway.
– 10 –
NOTICE!
Amplifiers using the trans• nova topology improve in sound quality after
warming up. We recommend operating the amplifier for approximately 15
minutes prior to evaluation under judging criteria or tune-ups to establish its
normal operating temperature.
* Your friends will call it MAGIC, you can call it Rockford technology! *