Rockford Fosgate 500.2 - Manual (Page 31)

– 28 –
500.
2
S
PECIFICATIONS
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V
Per channel into a 4
Ω
load 450 Watts
Per channel into a 2
Ω
load 730 Watts
Bridged into a 4
Ω
load 1460 Watts*
Continuous Power Rating (Competition Standard) - Measured at 13.8 Battery Volts
RMS continuous power per channel, both channels driven
into a 4
Ω
load from 20 to 20,000Hz with less than
0.05% THD (Total Harmonic Distortion) 250 Watts
RMS continuous power per channel, both channels driven
into a 2
Ω
load from 20-20,000Hz, with less than 0.10% THD 500 Watts
RMS continuous power mono, into 4
Ω
load
from 20-20,000Hz, with less than 0.10% THD 1000 Watts
Common Mode Rejection Ratio (CMRR): Typically 40dB
Signal-to-Noise Ratio: >100dB (A-weighted)
Frequency Response: 20Hz-20,000Hz
±
0.5dB
Bandwidth: 10Hz–250kHz
±
3dB
Damping Factor @ 4
Ω
(at output connector): >200
Slew Rate: 50V
µ
s
IM Distortion (IHF): <0.05%
Input Impedance: 20k Ohms
Source Unit Compatibility (+15dB gain overlap): 34V max.
Input Sensitivity (+0dB gain overlap): Variable from 350mV to 6V
Pass-Thru Output: Unity Gain
B+ Fuse Size: (External to amplifier) 100 Amp or two 50 Amp
Fuse Type: (1) ANL / (2) AGU
Crossover Slope: 12dB or 24dB/octave Butterworth
Factory Crossover Frequency: 80Hz (0.047
µ
f)
Factory Default Crossover Setting: Full Range
Dimensions: (including end caps) 9-5/8"W x 18-9/32"L x 2-5/8"H
(24.4cm) x (46.43cm) x (6.6cm)
Specifications subject to change without notice.
*This is the calculated Dynamic Power Rating. Actual output power exceeded the input capability of the PowerCube.