RayTek 3i - Manual (Page 47)

Raynger 3i Series Operator’s Manual 3-1
3.0 SPECIFICATIONS
This section covers the following specifications:
• Thermal
• Operational
• Electrical
• Environmental
• Physical
Also covered are factory default settings for each model as well as factory default set-
tings and range values for all models.
3.1 THERMAL
Table 3-1 lists thermal specifications for each model.
Table 3-1: Thermal Specifications
Measurement
Range
Spectral
Response
Detecting
Element
Display
Accuracy
Analog Output
Accuracy
Repeatability
Temperature
Coefficient
-30 to 1200
°
C
(-20 to 2200
°
F)
8 to 14 micron
Thermopile
150 to 1800
°
C
(300 to 3275
°
F)
5 micron
Thermopile
10 to 800
°
C
(50 to 1450
°
F)
7.9 micron
Thermopile
600 to 3000
°
C
(1100 to 5400
°
F)
1.0 micron
Silicon diode
200 to 1800
°
C
(400 to 3275
°
F)
1.6 micron
InGaAs diode
±
1% of reading (
±
0.5% for 1M) or
±
1
°
C (
±
1.5
°
F), whichever is greater, or
±
2
°
C (
±
4
°
F)
for targets below 0
°
C (32
°
F), at 23
°
C
±
5
°
C (73
°
F
±
9
°
F) ambient operating temp.
±
0.5% of reading or
±
1
°
C (
±
1
°
F), whichever is greater
±
3mV of display reading
±
0.1
°
C (
±
0.1
°
F) change per 1
°
C (1
°
F) change in ambient temperature
LT, LR, LRSCL2 1M 2M G5 P7
* The instrument may measure temperature a few degrees below the minimum and
above the maximum specified temperature range.
Note: Hi Alarm, Lo Alarm, and T. Ambient ranges are the same as measurement ranges in
Table 3-1.