Runco SP-42 - Manual (Page 37)

Runco CinemaWall SP Series Owner’s Operating Manual 27
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Attach the two included ferrite cores to each end of the AC power cable as shown in
Figure 4-1. Doing so will reduce radio frequency interference (RFI) emissions to a level
that conforms to FCC regulations. Use the supplied cable ties to secure the cores in
place.
Figure 4-1. Attaching the Ferrite Cores to the Power Cable
3. Plug the female end of the power cord into
the AC receptacle on the rear of the
CinemaWall (AC 100V ~ 240V). Connect the
other end to your AC power source.
4. Set the main power switch at the rear of the
CinemaWall (see Figure 2-2) to the “on”
position. Its power indicator lights red.
5. Press the POWER button on the underside
of the CinemaWall (see Figure 2-1) or the
remote control (see Figure 2-5). The power
indicator lights solid green.
6. After a brief warm-up period (approximately 10 seconds), the CinemaWall will display
an image.
4.2
Changing the OSD
Language The CinemaWall OSD language is initially set to English, but can also display the menus in
German (Deutsch), French (Français), Spanish (Español) or Italian (Italiano). To change the
OSD language:
1. Press MENU.
2. Press repeatedly to select Option from the Main Menu.
3. Press SET to select Language.
4. Press the right- or left-arrow button ( or ) to highlight the desired language and
press SET. The change takes effect immediately.
4. Operation
Ferrite core
Cable tie
AC power cord
To power outlet
As close as possible
To AC IN