Radio Shack Audio/ Video Remote Control - Manual (Page 15)

Need help? Call 1-888-284-8735
15
nel list, stopping on each channel for about 3
seconds.
6. Press any key when you see a channel you
want to watch. Scanning stops.
Note: If you do not program a favorite channel list,
SCAN acts as a “channel surf” key. Each time you
press SCAN , the 6-in-One repeatedly performs cy-
cles through the channels, stopping on each for
about 3 seconds.
Clearing Favorite Channel Scan
To change your favorite channel list, you must first
clear the existing list. Hold down
P until the red light
blinks twice. Press 9 9 6 , then hold down P until the
red light blinks twice. The list is cleared.
USING THE SLEEP FUNCTION
To use the sleep timer built into your TV, cable con-
verter, satellite system, or audio device, press
SLEEP . Most sleep timers advance in increments of
10 or 15 minutes. For specific instructions on setting
your device’s sleep timer, refer to the device’s own-
er’s manual.
If your TV, cable or satellite system does not have a
sleep timer, the 6-in-One has a built-in sleep timer
that can perform the function.
1. Press the appropriate device key.
2. Press SLEEP to set the 6-in-One’s sleep timer
for 15 minutes. The red light blinks once.
3. Each additional press of SLEEP adds 15 min-
utes to the sleep timer, up to 60 minutes. The
red light blinks twice when the sleep timer is set
15-1994.fm Page 15 Tuesday, February 29, 2000 2:04 PM