Radio Shack Audio/ Video Remote Control - Manual (Page 9)

Need help? Call 1-888-284-8735
9
3. Press VCR then hold down P until the red light
blinks twice.
4. Enter the 4-digit code.
For example, to replace a Panasonic TV/VCR
combination’s remote control (set-up code
1162), press
VCR , hold down P until the red light
blinks twice, then press 1 1 6 2 .
When the red light blinks twice, the remote con-
trol has accepted the code.
Note: If the code you entered is invalid, the red
light makes one long blink.
5. Point the 6-in-One at your TV/VCR combination
and press POWER or PLAY . Your TV/VCR com-
bination should turn off or start to play.
If the remote does not operate your TV/VCR combi-
nation, try the other codes you wrote down in Step 1.
Note: Some TV/VCR combinations require a second
code to control volume. If you cannot control the vol-
ume, use the TV code listed in “TV/VCR Combina-
tions” on Page 37.
15-1994.fm Page 9 Tuesday, February 29, 2000 2:04 PM