Using the remote control, Connecting the audio jacks, 17 rf-rbws02 – RocketFish RF-RBWSO2 User Manual

Page 17

Advertising
background image

17

RF-RBWS02

Using the remote control

• To avoid possible failure, read the following instructions and handle the

remote control properly.

• Do not drop or jar the remote control.

• Do not spill water or any liquid on the remote control.

• Do not place the remote control on a wet object.

• Do not place the remote control under direct sunlight or near sources of

excessive heat.

Caution

: Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type of battery.

Note

: Remove the battery from the remote control when it is not to be used for a long

period. Otherwise it might be damaged due to battery leakage.

Connecting the audio jacks

When the sender/receiver is connected to a power outlet, and an
audio source is attached to its 3.5mm AUDIO IN jack, it

is

sensed

automatically and used as a stereo sender. When the sender/receiver
is connected to a power outlet, and a speaker system is attached to
the AUDIO OUT jack, the output is always active assuming the RX LED
is lit and there is a valid sending device.

Note

: For devices that use variable line level out like the headphone jack on a personal

media player make sure that you turn the volume up to at least 80% of the maximum
volume on the device. This ensures that you keep your signal to noise ratio high and
maximize the sound quality.

A few configurations are shown here to provide ideas for your own
use:

RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 17 Thursday, August 27, 2009 7:39 PM

Advertising