RocketFish RF-RBWSO2 - Manual (Page 26)

26
To turn off the transmitter:
• Remove the 3.5 mm plug from the back of the unit and the transmitter
will automatically stop transmitting. The TX light will go out.
Troubleshooting
Check this list for a possible solution before calling for service.
Problem Solution
No sound • Make sure that all of the cables are connected correctly.
• Make sure that the audio source (at the unit or your
sender) is present.
• Make sure that the sender/receiver is not muted. (The
source Tx/Rx indicator is blinking when it is muted.)
• Make sure that the unit or your receiver's output is
connected to the speaker system, which is powered on
and working.
No communication
between the unit and your
device • Make sure that the Hub Status switch on the
sender/receiver is set correctly.
• Make sure that the power LEDs on the sender/receiver
and other devices light solid blue/green. If the power
LEDs blink slowly, it means there is no active link
between the devices. Unplug the AC adapters, then plug
them back in and try to establish the link again. For
more information, see “Establishing communication”
on page 21.
No response when you
press any button • Try disconnecting the main power to reset the device.
Connecting a source device • If your network is already full with transmitters when
joining is attempted, the Source LED will blink three
times and then turn off. Remove (power down) a
transmitting device and try again.
RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 26 Thursday, August 27, 2009 7:39 PM