RocketFish RF-RBWSO2 - Manual (Page 22)

22
To use the unit as a sender with another node as the hub (only follow these instructions
if you have an existing Rocketboost network. Otherwise skip to the Listening to Music
section):
1 Set the HUB STATUS switch to DISABLE.
Important : Make sure that the HUB STATUS switch is set to DISABLE before the
sender/receiver is turned on.
• The power-on indicator LED lights blue when the HUB STATUS
switch is set to DISABLE.
2 Press and hold the button on the sender/receiver for more than three
seconds to put it into joining mode for 30 seconds.
• The power-on LED on the sender starts blinking rapidly.
• The power-on LED lights steadily if the link is activated between both
of the units.
• The power-on LED blinks at a slower rate if the communication link is
not successful.
3 While the power-on LED on the sender is blinking rapidly, press the
Power button on the hub device for three seconds to put it into joining
mode. If successful, both lights will illuminate solidly. If the sender light
blinks slowly, retry the process.
4 If the source LED is not lit, press the Source button on the
sender/receiver to toggle to the next channel. If the LED still does not
light, make sure that the source is powered up.
TM
Power
on LED
RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 22 Thursday, August 27, 2009 7:39 PM