Warning, Caution, Caution to be taken for malfunctions – Renesas Emulation Probe M30850T-EPB User Manual
Page 10: Warning for handling this product, Warning for installation, Cautions for powering on, Cautions to be taken for handling this product, Warning for use environment
( 10 / 76 )
Caution to Be Taken for Malfunctions:
• If the emulator malfunctions because of interference like external noise, do the following to remedy
the trouble.
(1) Press the RESET switch on the emulator upper panel.
(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then
reactivate it.
WARNING
Warning for Handling This Product:
• Do not disassemble or modify this product. Disassembling or modifying this product can cause
damage.
Warning for Installation:
• Do not set this product in water or areas of high humidity. Spilling water or some other liquid into
the main unit can cause an unrepairable damage.
CAUTION
Cautions for Powering On:
• Turn ON the power of the emulator and target system as simultaneously as possible.
• Turn OFF the power of the emulator and target system as simultaneously as possible.
• Do not leave either the emulator or target system powered on, because of leakage current the
internal circuits may be damaged.
• When turning ON the power again after shutting OFF the power, wait about 10 seconds.
Cautions to Be Taken for Handling This Product:
• Use caution when handling the main unit. Be careful not to apply a mechanical shock.
• Do not touch the connector pins of the emulator main unit and the target MCU connector pins. Static
electricity may damage the internal circuits.
• Do not pull this product by the flexible cable for connecting to the emulator main unit and emulation
probe. The cable may cause a break.
• Do not flex the flexible cable for connecting to the emulator main unit and emulation probe
excessively. The cable may cause a break.
• Do not use inch-size screws for this equipment. The screws used in this equipment are all ISO
(meter-size) type screws. When replacing screws, use same type screws as equipped before.
Warning for Use Environment:
• This equipment is to be used in an environment with a maximum ambient temperature of 35
°C. Care
should be taken that this temperature is not exceeded.