Renesas Emulation Probe M30850T-EPB - Manual (Page 44)

( 44 / 76 )
(7) Connecting to a 100-pin 0.5-mm-pitch Foot Pattern (Part 3)
Figure 3.17 shows how to connect the emulation probe to a 100-pin 0.5-mm-pitch foot pattern on the
target system with the M3T-F160-100NSD (not included), and here following is its procedure. For
details on the M3T-F160-100NSD, refer to its user's manual.
(1) Mount the NQPACK100SD included with the M3T-F160-100NSD to the target system.
For details on how to connect the M3T-F160-100NSD, see its user's manual.
(2) Attach the YQPACK100SD included with the M3T-F160-100NSD to the NQPACK100SD.
(3) Insert the YQ-GUIDE's included with the YQPACK100SD to the YQPACK100SD.
(4) Attach the M30850T-EPB to the M3T-F160-100NSD.
(5) Attach the M3T-F160-100NSD to the YQPACK100SD.
Figure 3.17 Connecting to a 100-pin 0.5-mm-pitch foot pattern (3/3)
CAUTION
Notes on Connecting the Target System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulator.
• The small connectors of the M3T-F160-100NSD are guaranteed for only 50
insertion/removal iterations.