Rhinotek RHINO FL20 - Manual (Page 136)

Maintenance Section 5-6
MAINTENANCE
FL20MFL14M 10/03
MAINTENANCE
© 2004 Alamo Group Inc.
CAUTION Driveline Integral Shields must be in place at all times when operating.
FIGURE 8. Protective Driveline Shields Installation
PROTECTIVE, INTEGRAL SHIELDS - 44R
Protective Driveline Shields should be installed on Drivelines as shown below in FIGURE 8. The protective
Integral Shields are assembled onto nylon bearings and should turn freely - but should not spin. Greasing the
nylon bearings is not required but will not harm them. Each Shield Bearing is composed of two nylon bearing
halves. They may be removed by prying the locking lug of the nylon bearing out of the slot in the Shield and
pulling the bearing out through the slot. To replace the nylon bearings, align the slot in the shield over the
groove in the Yoke of the Driveline. Insert the beveled tip of the nylon bearing into the slot of the shield and
push into place. Push the locking lug of the nylon bearing into the slot until it snaps into place.