Rhinotek RHINO FL20 - Manual (Page 82)

Assembly Section 3-12 FL20M/FL14M 10/03
ASSEMBLY
ASSEMBL
Y
© 2004 Alamo Group Inc.
FIGURE 20
DRIVELINE ATTACHMENT
Remove Wing Nuts holding Divider Gearbox Shield and raise Shield. Remove any tape from Gearbox
shafts. Attach the Clamp Yoke end of the Wing Driveline to the Divider Gearbox. Tighten bolts evenly to
their proper torque. FIGURE 19. Attach the Torque Limiter to the Wing Section Gearboxes by sliding the
Limiter to the splined shaft on the Gearbox and tighten the set screw. Attach the Flange Yoke of the Wing
Driveline to the Torque Limiter with the bolts provided. Move yoke/limiter group back and forth to make sure
it is locked in place. FIGURE 20. Install the Main Driveline (CV) with slide collar to the Divider Gearbox by
sliding the collar back while attaching the yoke to the splined shaft on the Divider gearbox. Check to make
sure it is locked in place.
FIGURE 19
DRIVELINE CLAMP CONE YOKE OPERATING INSTRUCTIONS
Loosen the yoke clamp cone with a 11/16” (17mm) wrench and
remove the cone from yoke. Slide yoke onto the shaft and align
hole for clamping cone with annular groove of gearbox shaft.
Reinstall cone and tighten (75 lb-ft torque). Push and pull the
driveline to ensure it is securely attached to the shaft. Regularly
check the driveline yoke to ensure a tight connection. To remove
the yoke, remove the connecting cone and pull yoke off the shaft.
If the cone cannot be easily removed by hand, drive it out from
the other side using a hammer and punch.
NOTE: The clamping cone is serviced only as a complete
assembly. Do not attempt to disassemble the clamping cone.
Clamping Cone
Driveline Yoke
11/16" Bolt End
R 03-27-02