Rimage Everest III - Manual (Page 13)

Operate the Everest printer
110875_A 7

st
er. For more
Operate the Everest printer
This section provides the information needed to use your Everest printer.
Powering on and off the Everest printer
The Everest printer does not have a power switch:

Notes:
o
The printer goes into sleep mode if it is idle for more than 30 minutes. When this occurs,
the printer will take 2-3 minutes to warm up after a job is sent to the printer.
o
If the Everest printer is a standalone printer, connect the power cord from the Everest
printer to a power outlet to power on the printer. To power off the Everest printer,
disconnect the power cord.
Installing the Everest Printer Driver
Installing the Everest printer driver (PC)
Before printing, you must install the printer driver.
-
Important! If your Rimage Everest printer was included with an autoloader that has an
embedded PC or a control center, the Everest printer driver is already installed.
1. Connect the Everest power cord to the printer.
2. Ensure that the Everest printer is powered on.
Note: If the Everest printer is a standalone printer (not on an autoloader), the Evere
printer powers on when you connect the power cord. If the Everest printer is on an
autoloader, the Everest printer powers on when you power on the autoload
information, see
Powering on and off the Everest printer . Refer to page 7.
4. puter disc drive. The printer driver will automatically install
from the Rimage Software disc.
3. Connect the USB cable from the Everest printer to the computer.
Insert the software disc in the com