Radio Shack ET-2105 - Manual (Page 8)

7
date the wiring for you. You must use compatible modular jacks
that are compliant with Part 68 of
FCC Rules.
Note: The USOC number of the jack to be installed is RJ11C.
CONNECTING THE BASE
You can power the base using the supplied 12V, 200 mA AC/DC
adapter.
Cautions:
You must use a Class 2 power source that supplies
12V DC and delivers at least 200 mA. Its center tip
must be set to positive and its plug must fit the
phone's DC 12V 200mA jack. The supplied adapter meets
these specifications. Using an adapter that does not meet
these specifications could damage the phone or the adapter.
• Always connect the AC adapter to the phone before you con-
nect it to AC power. When you finish, disconnect the adapter
from AC power before you disconnect it from the phone.
Follow these steps to connect the base to a phone line and AC
power:
1. Plug one end of the supplied modular cord into the TEL LINE
jack on the back of the base.
2. Plug the modular cord’s other end into a modular phone line
jack.
3. Insert the supplied AC adapter’s barrel plug into the DC 12V
200mA jack on the back of the base.
4. Plug the adapter into a standard AC outlet.
!