Radio Shack 85 - Manual (Page 23)

23
OPERATION
TURNING ON THE AMPLIFIER
The amplifier automatically turns on whenever you turn your vehicle’s ignition
switch to ACC or ON. POWER lights when the amplifier is operating.
SETTING THE LEVEL CONTROL
For the best performance, you can adjust the level of audio signals that enter the
amplifier by following these steps.
Cautions:
• When the amplifier’s internal temperature reaches 202×F, the automatic
thermal protection system lowers the amplifier’s output power until it cools
down.
• The sound distorts if any output channel shorts. Turn off the amplifier and
try to locate the short.
• To prevent draining the vehicle’s battery, do not operate the amplifier using
the ignition switch’s ACC position for too long after turning off the vehicle’s
ignition.
1. Turn both LEVEL MIN/MAX controls fully counterclockwise to MIN .
Note: The right level control adjusts the inputs to CH1 and CH2 (normally
the front) and the left level control adjusts the inputs to CH3 and CH4 (nor-
mally the rear).
12-1977.fm Page 23 Tuesday, July 13, 1999 10:07 AM