Renesas Emulation Pod M37760T-RPD-E - Manual (Page 18)

( 16 / 64 )
Please keep the M37760T-RPD-E's packing box and cushion material in your place for reuse at a later
time when sending your product for repair or other purposes. Always use these packing box and
cushion material when transporting the M37760T-RPD-E.
If any of these items are missing or found faulty, please contact your local distributor. Also, if there
is any question or doubt about the packaged product, contact your local distributor.
2.2 Other Tool Products Required for Development
To bring forward programs development on the 7760 Group 7760/7762/776A MCUs, the products
listed below are necessary in addition to the package components listed above. Get them separately.
Other tool products
* To purchase these products, contact your local distributer.
* To purchase the LCC socket IC61-1004-051, contact your local distributor or Yamaichi
Electronics Co., Ltd.
Item
M37760T-RPD-E emulation pod main unit
FLX120-RPD flexible cable for connecting PC4701
M3T-FLX-100LCC pitch converter board for 100-pin LCC
OSC-2 oscillation circuit board (bare)
Hardware tool user registration FAX sheet (English)
Hardware tool user registration FAX sheet (Japanese)
M37760T-RPD-E User's Manual (this manual)
M37760T-RPD-E User's Manual (Japanese)
Quantity
1
1
1
1
1
1
1
1
Emulator main unit
Emulator debugger
Converter board
PC4701
M3T-PD77 (V.4.00 Release 1 or later)
For 100-pin 0.65-mm-pitch QFP (100P6P-E):
M3T-FLX-100LCC
(Please prepare separately the LCC socket IC61-1004-051
for connecting to the target system.)
M3T-FLX-100NRB
M3T-DUMMY100S
M3T-DIRECT100S
The converter board which matches to the foot pattern of the target
system is required.
(For connecting to the target system, see "3.5 Connecting the
Target System" on page 31.)
Chapter 2. Preparation
2.1 Package Components
This product consists of the following items. When unpacking, check to see if your product package
contains all of these items.
Package components