Renesas Emulation Pod M37760T-RPD-E - Manual (Page 41)

( 39 / 64 )
(3) Setting Debug Monitor Tab
CAUTION
Note on Monitor Work Area:
• Be sure to specify an area which can be read and written into as a monitor area. In
the monitor area 6 bytes of operation codes used in the emulator system are stored.
If these operation codes are rewritten, the emulator system will not work properly.
Therefore, do not access the monitor work area.
CAUTION
Note on Debug Bank Memory Area:
• In the debug bank memory area data used for the emulator system is stored. If the
data is rewritten, the emulator system will not work properly. Therefore, do not
access the debug bank memory.
CAUTION
Note on Watchdog Timer:
• When the watchdog timer is enabled, you can execute free run only.
Debug bank memory:
Set "FF" and, with this product, do not
change this setting.
Monitor work area:
Specify an area which can be read and
written into in the 0 bank. The specified
address is used as an work area, and
you can not use this address.
Watch dog timer:
Cancel the watchdog timer for normal
debug operations.
Settings
: Disabled (Watch dog timer prohibited)
: Enabled (Watch dog timer allowed)