Renesas Emulation Pod M37760T-RPD-E - Manual (Page 40)

( 38 / 64 )
CAUTION
Notes on Emulation Memory Settings:
• Set the SFR area (000000
16
- 0001FF
16
) to EXTERNAL.
• Set internal RAM area (001000
16
- 001BFF
16
) to INTERNAL.
Choose the "M37760mf.mcu" file for
M37760 Group MCUs.
4.4 Starting Up Emulator Debugger - Part 2 (Setting EMEM Dialog)
The EMEM dialog box will appear after the settings in the Init dialog box by starting up the emulator
debugger or downloading the firmware. Here explains how to set the processor mode of the target
MCU, allocate the emulation memory and set the debug monitor area. The dialog box shown below
is an example of the emulator debugger M3T-PD77 V.4.00 Release 1. The display and setup items
may vary according to the version of the M3T-PD77. For more details, refer to M3T-PD77 User's
Manual.
Figure 4.4 Emem dialog display
(1) Setting Processor Mode Tab
Be sure to use single-chip mode as a processor mode.
(2) Setting MAP Tab
Debug Monitor tab
MAP tab
It is not necessary to set these tabs for this product.
Processor tab