Raritan Computer MasterConsole Z - Manual (Page 30)

24 M ASTER C ONSOLE Z U SER G UIDE
Q UESTION : A NSWER :
I disconnected a complete MZCIM chain from
the UMT and added it to the tail of another
MZCIM chain. I was finally able to see all the
MZCIMs but it took almost a minute. What
happened? Prior to connecting the chains, you had one
Master per chain. There only can be one
Master per chain. When you connected the
chain, there were suddenly 2 Masters in the
chain. It took a while for this condition to
clear. This is normal operation.
I have a MZZCIM that is beeping every 30-40
seconds. Also, I noticed that the LED is
blinking very rapidly. Why is this happening? A MZCIM will beep once every minute to
notify the user that it did not get a
Communication Address. The user should
check to make sure that the number of
MZCIMs has not exceeded the Chain size. If
the size is correct, the problem should
disappear after a couple of minutes. If not,
check again to make sure the chain size is
correct. The beeping MZCIM will increase
the Communication Address Request delay to
40-55 seconds. The data collision introduced
by continued Communication Address
requests should not affect keyboard and
mouse functionality, however if there are
many units which can not get Communication
Addresses it might cause slower keyboard
and mouse response. Beeping MZCIMs can
also occur if the 2 chains are connected
together to make one chain.
The MZCIM beeps when it first receives
power. Why? This is normal operation. The beep notifies
the user that the MZCIM has powered up
correctly.
My mouse seems to be erratic and jumps
around opening windows. What's happening? There is a possibility that the proper mouse
driver is not loaded or the mouse is not
recognized. Check to make sure the mouse
driver is correct for the mouse type you are
using.