Operation, Making and answering calls, Switching between the handset and the headset – Radio Shack ET-007 User Manual

Page 14

Advertising
background image

14

OPERATION

MAKING AND
ANSWERING CALLS

Using the Handset

To make a call, pick up the handset and
dial normally. The IN USE indicator
flashes when you receive a call and
lights while the phone is in use.

Pick up the handset to answer a call and
place the handset on the base to end a
call.

Note: The corded phone will not operate
without AC power. During a power fail-
ure, use a backup battery for the base
corded phone, or another phone on the
same line.

Using the Wireless Headset

1. Place the wireless headset on your

head and adjust the headband and
microphone for a comfortable fit.

2. Pull down the microphone until it

clicks and you hear a dial tone. Dial
the desired number using the infra-
red remote dial card.

3. To answer an incoming call, pull

down the microphone until it clicks
and wait about 1 second.

Notes:

• If the headset is on the headset

charger and the microphone is
pulled down, place the headset
on your head, then press

PHONE/

FLASH

on the infrared remote dial

card to answer a call.

• The headset only receives a sig-

nal from the remote dial card if
the microphone is pulled down.
The dial card does not work if the
microphone is pulled up.

4. When you finish a call, pull the

microphone up until it clicks, or
press

OFF

on the infrared remote

dial card, or put the headset back on
the headset charger.

Notes:

• The infrared remote dial card only

controls the headset, not the corded
phone.

• If the headset does not work, move

the dial card closer to the sensor on
the left side of the headset. If it still
does not work, replace the battery in
the dial card.

SWITCHING BETWEEN
THE HANDSET AND THE
HEADSET

Using Hold

To switch from the handset to the head-
set, press

HOLD

on the corded phone,

then place the handset on the cradle.
The IN USE/BATT. LOW indicator on
the headset and the HOLD indicator on
the base flash. Put on the headset and
pull down the microphone. The HOLD
indicator on the base turns off, while the
IN USE/BATT. LOW indicator on the
headset lights and the IN USE indicator
on the base flashes.

43-007.fm Page 14 Wednesday, March 22, 2000 11:24 AM

Advertising