Mounting the corded phone on a wall or wall plate – Radio Shack ET-007 User Manual

Page 8

Advertising
background image

8

• The INTERCOM and HOLD indi-

cators on the corded phone stop
flashing after the headset charger
and wireless headset are con-
nected, even when there is no
battery pack in the headset. If
they flash, move the headset and
charger closer to the corded
phone.

Remove the battery insulation strip from
the infrared remote dial card’s battery
compartment. Then place the dial card
in its cradle on the headset charger.

If you cannot operate the headset using
the remote dial card, you might need to
replace the dial card’s battery. Slide off
the battery compartment cover and use
a pointed object (such as a straightened
paper clip) to gently pry out the old bat-
tery. Insert a fresh CR2025 lithium but-
ton-cell battery (available from your local
RadioShack store), then replace the
cover.

Note: To detach the supplied carry
strap, gently pull on the carry strap’s
small loop, then pull the strap through
the small loop. To reattach the strap,
slide the small loop into the carry strap
slot on the remote dial card. Then insert
the strap through the small loop and pull
to tighten.

MOUNTING THE CORDED
PHONE ON A WALL OR
WALL PLATE

You can use the supplied mounting
bracket to mount the corded base phone
on a wall.

Notes:

• When mounting the base telephone

on a wall plate, use the supplied
modular cord to connect the phone
to the wall plate jack.

• To mount the base telephone

directly on a wall, use two

3

/

16

-inch

(5mm) screws (not supplied). Drill
two holes 3

15

/

16

inches (100 mm)

apart. Then thread a screw into
each hole, letting the heads extend
about

1

/

8

inch (3 mm) from the wall.

1. To connect the bracket, insert the

tabs on the bracket into the slots in
the lower position on the base. Then
press the upper side of the bracket
to the base until it snaps into place.

To remove the bracket, press in the
upper tab on each side of the
bracket and lift the bracket away
from the base.

2. Plug one end of the supplied modu-

lar cord into the phone’s

TEL.LINE

jack and the AC adapter's barrel
plug into the DC jack.

43-007.fm Page 8 Wednesday, March 22, 2000 11:24 AM

Advertising