Radio Shack ET-007 - Manual (Page 7)

7
4. Route the adapter's cord through
the strain relief slot on the bottom of
the phone.
5. Lift the base telephone's antenna to
a vertical position.
CONNECTING THE
HEADSET CHARGER,
WIRELESS HEADSET AND
INFRARED REMOTE DIAL
CARD
To connect the headset charger, con-
nect the headset charger’s built-in AC
cord to the AC outlet. The plug fits only
one way.
Follow these steps to connect the wire-
less headset:
1. Slide open the battery compartment
cover on the left side of the headset.
2. Install the supplied rechargeable
nickel-metal hydride (Ni-MH) battery
pack in the headset’s battery com-
partment with the battery contact
points down.
Important: You must install the bat-
tery pack and fully charge it before
you can use the headset (see
“Charging the Battery Pack” on
Page 10).
3. Replace the cover.
4. Place the headset on the headset
charger. The charging indicator on
the headset lights red, then flashes
slowly when the battery pack is fully
charged.
Notes:
• The charging indicator lights
when the headset is on the head-
set charger, even if there is no
battery pack in the headset. Be
sure the battery pack is inserted
before charging.
Headset
Charger
Wireless
Headset
Battery
Pack
43-007.fm Page 7 Wednesday, March 22, 2000 11:24 AM