Roland FJ-40 - Manual (Page 33)

31
2 Basic Operation
2-7 Ending Printing Operations
If you wish to cut off the piece of the rolled material
containing the printed area, press the [SHEET CUT]
key. Hold down for about 2 second.
The piece is cut off at the present location of the
printing-start line.
* This operation isn't
necessary when sending a
material-cutting command
from the computer to
separate the material
automatically.
1 Press the [SETUP] key. Hold down for about 1
second. 2
Move the sheet loading lever toward the back of the
unit.
The pinch rollers rise to release the material. 3
Remove the Material
Open the front cover.
To remove the material, follow the steps for loading it
in reverse. 4
Separating the Printed Portion
Either of two methods can be used to separate a portion that's already been printed from the roll. One method is to press the [SHEET
CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
When separating the material by pressing the [SHEET CUT] key
Holding down the [SHEET CUT] key for 2 seconds or longer severs the material at the present position of the printing-start line.
Sheet loading lever
The material is cut off here. Knife guide
Printed portion
Printing-start line
The SETUP LED goes out