Roland FJ-40 - Manual (Page 48)

46
4 User's Reference
4-3 Printing Area
The material's printable width (the direction of carriage movement) is determined by the width of the loaded material. When the
[SETUP] key is pressed after loading the material, the width of the material is detected and the printing area appears on the display. The
printing area is normally 10 mm (3/8") inward from the respective left- and right-hand edges of the material.
When the printable width have been specified with the [PRINT AREA] menu, the margins are in accordance with these setting values.
10 mm (3/8")
Origin (0, 0)
Printing area
Material
Max. : [FJ-50] 1320 mm (52")
[FJ-40] 1066 mm (42")
Length of
one roll
10 mm (3/8")
10 mm (3/8")
51.5 mm (2-1/16")
When the printable width have been specified with the [PRINT AREA] menu,
the margins are in accordance with these setting values.