Roland FJ-40 - Manual (Page 52)

50
4 User's Reference
4-5 Description of Keys and Display Menus
Description of Keys
Default
value
Setting
range
Function Submenu
Top
menu
Key
— — — — This switches on and off the sub power . When the
power is switched on, the POWER LED lights up.
— — — — This detects the presence and the width of the material,
and displays the printable width.
The SETUP LED flashes while detection of material
width is in progress. When setup finishes, the SETUP
LED lights up continuously.
Also press this key when removing the material.
— — — — The [PAUSE] key pauses operation. The PAUSE LED
lights up while paused.
Pressing this key again cancels the paused state.
Holding down the [SETUP] key for about 1 second
while paused causes remaining data to be cleared and
cancels the material's setup state.
— — — — This sets the print-start location in the horizontal
direction (the direction of carriage movement). For
more information, see "2-6 Performing Printing --
Performing Printing at the Desired Location -- Specify-
ing a location in the left-right direction (the direction of
carriage movement)."
PRINT
QUALITY
— [Printing
quality]
PHOTO
SUPER
FINE
NORMAL
FAST
DRAFT
[Printing
direction]
UNI-DIRECTION
BI-DIRECTION
[Printing
quality]
FINE
[Printing
direction]
BI-
DIRECTION
This displays the [PRINT QUALITY] menu for setting
image quality.
This is used to specify the printing quality and unidi-
rectional or bidirectional printing.
Settings cannot be made while printing is in progress.
To exit the [PRINT QUALITY] menu screen, press the
[MENU] key or the [CLEANING] key or the [SETUP]
key.
For more information, see "2-6 Performing Printing --
Setting the Printing Mode."
HEAD
CLEANING
START
TEST
PRINT
— — This displays the [HEAD CLEANING] menu for
cleaning of the printing head. Before starting to print,
you can carry out a printing test to check the printing
quality.
You can perform cleaning while in any state. Note that
[TEST PRINT] is not displayed while the printing is in
progress.
[TEST PRINT]: Performs a printing test within an area
of approximately 54 mm (2-3/16") by 18 mm (6/8"). If
there is a problem, then continue by carrying out
cleaning from the [START] menu.
[START]: Begins cleaning of the printing heads. After
cleaning, carry out a printing test to make sure there are
no problems.
For more information, see "2-5 Test Printing" and "3-3
Cleaning the Printing Heads."